Volkswagen ID.3: Technical data. Safety information

• Safety information - body repairs
• The following body repairs require the HV electrical system to be de-energised
• When the high-voltage battery is removed, observe the following:

Safety information - body repairs

Safety information - body repairs

WARNING

Gases/ vapours hazardous to health are generated when welding, soldering or cutting using tools which produce sparks in foam-treated areas.

– Do not weld, solder or cut closer than 15 mm to moulded foam inserts.

– Use an extraction system during work.

♦ Observe safety information ⇒ General information; Body repairs; General body repairs; Safety information

♦ Use local exhaust ventilation when performing welding and grinding work.

♦ Clean exhaust extraction system at regular intervals.

♦ Do not carry out welding and grinding processes in same room at same time.

♦ Remove dust regularly from work areas.

♦ Do not blow off dust deposits with compressed air.

♦ Observe the respective country-specific accident prevention and health and safety regulations.

The following body repairs require the HV electrical system to be de-energised

The following body repairs require the HV electrical system to be de-energised

De- energising the high-voltage system is carried out exclusively by means of “Guided Fault Finding”, see chapter on De-energising high-voltage system → Electric drive rear-wheel drive EIP220 and all-wheel drive EIA200, EIP220; Rep. gr.93; De-energising high-voltage system.

♦ A high-voltage technician must de-energise the system prior to welding, grinding and cutting work in the vicinity of high-voltage components.

♦ A high-voltage technician must de-energise the system prior to body work with the alignment jig.

♦ De-energisation measures may only be carried out by electrically instructed persons.

♦ For information refer to the vehicle-specific repair manual. ⇒ Power unit; Repair group 93; Electric motor; Hazard rating of high-voltage system

When the high-voltage battery is removed, observe the following:

When the high-voltage battery is removed, observe the following:

♦ When the high-voltage battery is removed, avoid contact with the vehicle floor.

Technical data. Vehicle identification dataTechnical data. Body parts and materials